The V-Kote Tek™ waterproofing system is the process of fusing two PVC surfaces permanently together.

Any waterproofing system is only as good as its weakest point. With over 25 years in the deck waterproofing industry, DEC-K-ING knows from experience where water is most likely to infiltrate the building envelope. V-Kote Tek™ is engineered to add protection to the most critical areas of a project, offering PVC coated accessories and pre manufactured boots to ensure factory consistency throughout. Reinforced PVC membrane details previously impossible to make, extending in multiple directions, are now manufactured by sophisticated electronic equipment. V-Kote Tek™ is the most technologically advanced deck waterproofing system on the market.

V-Kote Tek™ Details
Corners: Every corner is sealed 100% and is consistent throughout the project.	PVC Coated Metal Flashing: Membrane is heat welded permanently to top of PVC coated flashing rather than bent over flashing which only adds stress to the membrane.
Termination: Wall/deck transition piece protects structure from water returning off the drip flashing.	Scuppers & Overflows: Spun aluminum, PVC coated unit; deck membrane heat welded to flange. A special skirt is also welded to outside wall. Seals permanently inside and outside of structure.
Drains: One- piece metal drain is PVC coated. Membrane is permanently heat welded to drain. No glue. No caulking.	Post Boot: The entire post is wrapped in one piece with the overlap heat welded to the PVC membrane.
Door Corner Boot: Protects the critical area with a one-piece factory made unit.	Downspout Boot: One-piece, factory made downspout boot seals the entire unit.
Railing Boot: Keeps water away from the base and fasteners. Boot is heat welded permanently to the deck membrane.
> Railings on Parapet Walls: Railing base plate is chemically bonded to a 60-mil PVC membrane and fused to the PVC coated flashing. Railing base plate is also sealed to the PVC membrane with a PVC rod.